Inputs:
Channels: Switchable microphone or line input
Connectors: 2 x Combo XLR 1/4" phone jack, balanced microphone/line input
2 x RCA L/R, unbalanced aux input
1 x 3.5 mm stereo phone jack, unbalanced aux input
Line mode:
Gain adjustment range: +3 to +20 dB
Minimum input voltage: 100 mV @ -20 dBV
Maximum input voltage: 3 V @ +10 dBV
Input impedance: 2.2 Mohms, 60 pF
Signal-to-noise ratio, A-weighted
Minimum gain: 108 dB
Maximum gain: 98 dB
Frequency response: 20 Hz - 20 kHz @ ±1 dB
THD + N (1 kHz): < 0.3%
Microphone mode:
Gain adjustment range: +4 to +40 dB
Minimum input voltage: 10 mV @ -40 dBV
Maximum input voltage: 3 V @ +10 dBV
Input impedance: 2.1 kΩ
Unbalanced: 1.1 kΩ
Signal-to-noise ratio, A-weighted
Minimum gain: 108 dB
Maximum gain: 93 dB
Frequency response: 20 Hz to 20 kHz @ ±1 dB
THD + N (1 kHz): < 0.1%
Phantom power: 24 V, R = 1.2 kΩ per terminal, switchable for each channel, total current maximum 10 mA per channel, short circuit protected
Indicators:
LED Red
Headroom: 8 dB
AUX Input: Level control
Minimum input voltage: 2 x 250 mV @ -14 dBV
Maximum input voltage: 2 x 10 V @ +20 dBV
Input impedance: 10 kΩ
Outputs
Connectors: 1/4" phone jack, line output
1/4" phone jack, headphones output
XLR male, DI output
Line Out Nominal output voltage: 1 V @ 0 dBV
Maximum output voltage: 9 V @ +19 dBV
Output impedance: 47 Ω
Min. load impedance: 2 kΩ
Residual noise (master fully anticlockwise): A-weighted: 1 µV @ -120 dBV
Headphones: Output power, 1 kHz, THD = 1%:
Typ. 2 x 40 mW / 32 Ω
Residual noise (master fully anticlockwise): A-weighted: 3.3 µV @ -110 dBV
Note: Suitable for headphones with stereo phone jack only. Do not connect any mono phone jacks.
DI Output Level control
Nominal output voltage (differential), adjustment range: 41 to 410 mV @ -28 to -8 dBV
Output impedance:
47 Ω each terminal to ground
Minimum load impedance (differential): 1 kΩ
Residual noise (both channels in line mode), A-weighted: 3.3 µV @ -110 dBV
Tone Controls Low: ±12 dB at 100 Hz (shelf type)
High: ±13 dB at 10 kHz (shelf type)
Effects Built-in effect: Digital effect processor with 4 presets
1 = Reverb with short predelay
2 = Reverb with long predelay
3 = Repeating delay
4 = Chorus
Footswitch Connector: 1/4" stereo phone jack, channels mute control
Function: Switch ON = channel muted
Power: Supply voltage: 24 VDC, 0.5 A
Mains adapter: Mains voltage: 100 - 240 VAC
Power consumption when used with Dual Mix: maximum 10 W
Housing: Aluminum
Finish: Anodized black
Dimensions: 2.56 x 4.13 x 5.31" (65 x 105 x 135 mm)
Weight: 1.06 lb (480 g)
