Input: Switchable microphone or line input
Combo XLR-1/4" jack
Line Mode Unbalanced high impedance input for instrument pick-ups and line-level sources
Gain Adjustment Range: +3 to +20 dB
Minimum Input Voltage: 100 mV @ -20 dBV
Maximum Input Voltage: 3 V @ +10 dBV
Input Impedance: 2.2 MOhms, 150 pF
Signal-To-Noise Ratio (A-weighted):
Minimum Gain: 104 dB
Maximum Gain: 98 dB
Frequency Response: 20 Hz to 20 kHz @ ±1 dB
THD + N (1 kHz): < 0.3%
Microphone Input Balanced microphone input: ground, positive, and negative
Gain Adjustment Range: +4 to +40 dB
Minimum Input Voltage: 10 mV @ -40 dBV
Maximum Input Voltage: 3 V @ +10 dBV
Input Impedance: 2.1 kOhms
Unbalanced: 1.1 kOhms
Signal-To-Noise Ratio (A-weighted):
Minimum Gain: 104 dB
Maximum Gain: 95 dB
Frequency Response: 20 Hz to 20 kHz @ ±1 dB
THD + N (1 kHz): < 0.1%
Phantom Power: 24 V, R = 1.2 kOhms per terminal, switchable, total current max. 10 mA, short circuit protected
Indicators: Clip LED: Red
Headroom: 12 dB
Outputs
Line Out 1/4" Mono phone jack
Nominal Output Voltage: 1 V @ 0 dBV
Maximum Output Voltage: 9 V @ +19 dBV
Output Impedance: 47 Ohms
Minimum load Impedance: 2 kOhms
Residual Noise (master fully anticlockwise):
A-weighted: 1.2 µV @ -118 dBV
DI Output Balanced XLR Output: ground, positive, and negative
Level Control
Nominal Output Voltage (differential), adjustment range:
41 to 410 mV @ -28 to -8 dBV
Output impedance:
47 Ohms each terminal to ground
Minimum Load Impedance (Differential): 1 kOhms
Residual Noise (both channels in line mode):
A-Weighted: 2.3 µV @ -113 dBV
Controls
Tone: Flat if intensity is set fully anticlockwise. The following values apply if intensity is set fully clockwise:
Balance Left: +9 dB at 100 Hz, shelf-type
Balance Center: +7 dB at 100 Hz, and +12 dB at 10 kHz, shelf-type
Balance Right: -1 dB at 50 Hz and +12 dB at 10 kHz, shelf-type
Enhancer
Frequency Response: +3 dB at 10 kHz
Harmonic Distortion: THD: 10% at 1 kHz
Parametric Equalizer: Adjustable band boost / cut (bell curve) filter
Frequency Range:
90 Hz to 1.6 kHz / 680 Hz to 11 kHz (switchable)
Gain Range: @ ±15 dB at center frequency of filter
Bandwidth Range: 0.4 - 2.2 octaves
Power
Supply Voltage: 24 V, 0.2 A
Adapter: Mains Adapter: Mains Voltage: 100 - 240 VAC
Power Consumption When Used with Colourizer: Maximum 10 W
General
Housing: Aluminum
Finish: Anodized black
Dimensions: 2.56 x 4.13 x 5.31" (65 x 105 x 135 mm)
Weight: 1.06 lb (480 g)